Frets On The Net

Engraved Gibson Case Tags 1/32nd X 1-1/2” X 13/16ths: $25.00 each in Solid Unclearcoated Brass.

Contact

Frets On The Net Quality custom parts.... ....built just for you.

Email Me: HERE

Engraved Gibson / Epi Truss Rod Covers: $20-$22 each in Plastic

Brass and Aluminum, Polished, Relic'd, or Satin finished $30-$35 (Some engravings, depending on detail, may be more)

Custom Switch Plate Washers NOTE* I've had some customers concerned with how far away the "words" were engraved from the center mounting hole. This is needed to make room when the nut is installed for the switch, the "words" will be centered and located properly. $20.00 Each

• White with Black Engraving • Black with White Engraving • Black Gloss with Gold Engraving

Brass and Aluminum, Polished, Relic'd, or Satin finished $30-$35 (Some engravings, depending on detail, may be more)

More Possibilities in Shapes and Materials:

Signatures can be done as well!

Misc. Gibson and Epiphone Parts

Black Anodized Aluminum (engravings are available)

Aircraft Uncleared Aluminum Available in Satin, Polished or Brushed! $22 Each Ring

Black Anodized Aluminum Available in Satin, or Brushed! $24.00 Each Ring

Gibson / Epiphone Thunderbird Ring Thanks to the guys over at the "Dudepit", I offer these hard to find 60's and 70's versions of these pickup rings. The pic below is the 60's version with the larger outside Radii. The 70's version with the smaller radii is also available. These are made from polished aluminum with the correct thickness of the originals. I can now offer these for the modern size pickups as well, please Inquire. Click Here for an Installation Tutorial. Thanks to David Garrity:

Black Brushed Anodized Aluminum finished $30-$35 (Some engravings, depending on detail, may be more)

Natural Domestic and Exotic Wood, in Oil or Natural finished $25.00 Engraving is available, but not in all fonts because of wood grain limitations. Bolivian Rosewood and Black Walnut shown below.